|
| Yamaha YZF R1 SS LED Tag Bracket (04-06) |
SS LED FENDER ELIMINATOR KIT WITH LED TURN SIGNALS AND LED TAG LIGHT. Fits 2004-2006.
Available in Black, CLEAR BLUE TAG or CLEAR RED TAG. |
| |
| Item no.Y0406R1SS |
Retail: $109.95(PLUS shipping) |
| Today$99.95 |
|
|
|
|
| Application Chart |
Diagrams |
Application
Notes |
|
| 2004 Yamaha YZF R1 |
|
|
| 2005 Yamaha YZF R1 |
|
|
| 2006 Yamaha YZF R1 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| WARNING: Laws concerning this product vary from state/province to state/province. Your state/province may prohibit its use on public roads or restrict its use to novelty, show use, off-road areas, or race facility areas only. In some states/provinces off-road uses are also prohibited. The manufacturer and retailer assume no responsibility for any use or application of this product in violation of any applicable law. Before installing this product, please check your state/provincial and local/municipal laws and regulations. |
|
| The Q&A on this Product |
|
|
| QUESTION: what up with the colors, whats that for is it something you can see with the plates on? |
| ANSWER: NO. YOU CAN ORDER THE TAG BRACKET IN RED OR BLUE IF YOU DON'T WANT BLACK. |
|
| QUESTION: Are these kits available without turn signals? |
| ANSWER: part number is YR10406SSNOT/S |
|
| QUESTION: I am looking for the tag, no light for the 2007 yamaha r1, ss kit. |
| ANSWER: comes with the tag light. you can remove it. |
|
| QUESTION: hi what are the difference of this product number "1Y1006" and this item no "Y0406R1SS,how come the led is much cheaper than the regular buld,coz the other 1 is 146$ and the led 1 is only 129$,thanks mike |
| ANSWER: different manufacturers. |
|
| QUESTION: Legal in Washington or not? |
| ANSWER: you would have to check with local law enforcement. |
|
| QUESTION: What do I connect the two resistors to? Blinkers or tail lights? |
| ANSWER: the load resistors are for the turn signals. |
|
| QUESTION: would this fit on a 2006 yamaha r6 |
| ANSWER: yes |
|
| QUESTION: CAN I USE THIS KIT ON MY 2006 YZF R1 OR DO I HAVE TO WAIT FOR A KIT TO COME OUT FOR THE 06'S ? I CAN'T STAND LOOKING AT THE FACTORY FENDER ANYMORE! |
| ANSWER: the 06 is the same as the 05. |
|
| QUESTION: if u don't have to drill holes for the fender eliminator, where do u run the wires from? if u can send pix that would be great |
| ANSWER: in between the 2 pegs there is 2 push tabs, you run them through there |
|
| QUESTION: does this block off the stock fender holes and do you have to drill new holes for the new one?? |
| ANSWER: this will come with cover plates to cover the stock holes and the kit requires no cutting or drillind a complete bolt on using exsisting holes on the 04-05 r1 thanks oliver |
|
|
|
| Ask your question here: |
|
| Your email (so we can send you the answer): |
|
|
|
Event Schdeule
powered by WordPress e-commerce company