|
| YAMAHA R1 SS FENDERELIMINATOR TAG BRACKET 2007 Without Turn Signals |
Fits New 2007 R1
picture shows turn signals but this part number has no signals.
This kit positions the tag in front of the back tire, giving the bike a much cleaner look! Very easy to install and includes LED tag light, all stainless hardware, load resistors, and instructions. Available in Black, CLEAR BLUE TAG or CLEAR RED TAG.
|
| |
| This item usually takes about 2 days to ship |
| |
| Item no.Y0708R1SS |
Retail: $75.00(PLUS shipping) |
| Today$72.95 |
|
|
|
|
|
|
|
|
|
|
|
|
| This item does NOT ship for free |
| Shipping charges will apply to this item. If you place your order now we will call with the shipping rate. If the rate is approved by you we will charge you the additional shipping. If the rate is NOT approved by you then we will cancel your order. If you do not wish to place your order now you can enter in the quantity you wish to order and your zip code in the Q&A section below and we will respond with a quote. |
|
|
|
| ALSO AVAILABLE WITHOUT TURN SIGNALS.
|
|
|
| WARNING: Laws concerning this product vary from state/province to state/province. Your state/province may prohibit its use on public roads or restrict its use to novelty, show use, off-road areas, or race facility areas only. In some states/provinces off-road uses are also prohibited. The manufacturer and retailer assume no responsibility for any use or application of this product in violation of any applicable law. Before installing this product, please check your state/provincial and local/municipal laws and regulations. |
|
| The Q&A on this Product |
|
|
| QUESTION: does this require any drilling or rewiring ? |
| ANSWER: you have to wire in the tag light. no drilling required, but i do reccomend making a pre existing hole larger. |
|
| QUESTION: Where does the bracket bolt in? The holes shown are used for other screws/plugs. Thank you. |
| ANSWER: YOU USE THOSE HOLES TO HOLD THE BRACKET, KIT INCLUDES REPLACEMENT STAINLESS STEEL NUTS, WASHERS, AND BOLTS |
|
| QUESTION: sorry 1 more question is this a direct bolt on or do i have to modify the tail |
| ANSWER: bolt on |
|
| QUESTION: IS THIS PART METAL OR HARD PLASTIC |
| ANSWER: STRONG abs plastic |
|
| QUESTION: do u guys send 2 australia at all by any chance |
| ANSWER: Sure |
|
| QUESTION: Thanks.....Could you send the part number for the one for the 06 R1 with signals.... |
| ANSWER: y07r1ss |
|
| QUESTION: Will this fit the 2006 R1??? |
| ANSWER: WELL, ACTUALLY YES. BUT THE PART NUMBER YOU ARE LOOKING FOR IS Y0406R1SS |
|
|
|
| Ask your question here: |
|
| Your email (so we can send you the answer): |
|
|
|
Event Schdeule
powered by WordPress e-commerce company