|
|
|
|
|
|
|
|
|
|
|
|
| This item does NOT ship for free |
| Shipping charges will apply to this item. If you place your order now we will call with the shipping rate. If the rate is approved by you we will charge you the additional shipping. If the rate is NOT approved by you then we will cancel your order. If you do not wish to place your order now you can enter in the quantity you wish to order and your zip code in the Q&A section below and we will respond with a quote. |
|
|
|
| WARNING: Laws concerning this product vary from state/province to state/province. Your state/province may prohibit its use on public roads or restrict its use to novelty, show use, off-road areas, or race facility areas only. In some states/provinces off-road uses are also prohibited. The manufacturer and retailer assume no responsibility for any use or application of this product in violation of any applicable law. Before installing this product, please check your state/provincial and local/municipal laws and regulations. |
|
| The Q&A on this Product |
|
|
| QUESTION: Are the end caps removable? Will the bars accommodate bar ends? |
| ANSWER: You can get them out. They are .625 ID for reference when sourcing bar ends (GSXR units generally work). |
|
| QUESTION: I am looking for 12 inch bars. When you say they are 12 inches "tip to tip" is that including the bar end cap or Just the aluminum tube?
THANKS |
| ANSWER: Hello
The aluminum tubing is 11" long with the caps adding about another inch.
Thanks
Greg Souther
Woodcraft Technologies |
|
| QUESTION: What is the I.D. (Inner diameter)of these bars? |
| ANSWER: appx 0.625 inch |
|
| QUESTION: is this bar 1 inch wide?? |
| ANSWER: 7/8" in diameter - very standard |
|
| QUESTION: will these bars work with oem clipons kaw ex 250 |
| ANSWER: No, they will not. You would need the whole clipon assembly. |
|
| QUESTION: Hi I have a susuki sv650s 2000 reg, do you produce clip ons and risers for this model. thanks |
| ANSWER: We have clipons that are used by many racers for that bike, but they are not risers... |
|
| QUESTION: do they come in colours |
| ANSWER: Since they get 90% covered up, they are available only in silver. |
|
| QUESTION: I have an 06 vmax and am looking to streach out a bit and I think your product will work for me, but my handlebar diameter is 7/8". Will my controls(reservoirs/kill switch)fit on these bars without shimming? Thank you,Jason |
| ANSWER: Yes, they will |
|
| QUESTION: What lenghts do the woodcraft bars come in?
I need 11" bars.
Any other clip-ons with 11" bars?
Thanks, Jeff |
| ANSWER: The bar tube length is 12" tip to tip. |
|
| QUESTION: hey i have a 2000 zx7r would this part fit my bike all i need is the handle bar.. thanks |
| ANSWER: These bars do not fit on OEM clipons.....when you remove your ZX7 bar, you'll see why - they are a pain in the neck, you have to take apart the whole front end to change a bar. |
|
|
|
| Ask your question here: |
|
| Your email (so we can send you the answer): |
|
|
|
Event Schdeule
powered by WordPress e-commerce company