|
| Woodcraft 50mm Clip-ons - 1-1/2`` Riser |
These clipons have a one inch rise over a conventional 50mm clipon. This rise is very similar to the stock rise on a GSXR handlebar. This clipon will give you the ability to have a race style clipon assembly with the option to get the bars up a little higher. This is a UNIVERSAL application - you must determine the fit and application of these riders to your motorcycle. Once installed in any way (screws tightened) they may NOT be returned. You may need to modify any of the following: Brake lines, Throttle cables, Clutch lines/cables, or electrical wiring harnesses. |
| |
| Item no.12-2550 |
Retail: $179.99(PLUS shipping) |
| Today$169.95 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| WARNING: Laws concerning this product vary from state/province to state/province. Your state/province may prohibit its use on public roads or restrict its use to novelty, show use, off-road areas, or race facility areas only. In some states/provinces off-road uses are also prohibited. The manufacturer and retailer assume no responsibility for any use or application of this product in violation of any applicable law. Before installing this product, please check your state/provincial and local/municipal laws and regulations. |
|
| The Q&A on this Product |
|
|
| QUESTION: I have an 03' CBR 954rr, i'm looking for something similar to OEM. would this be a good choice? |
| ANSWER: Yes, this should be very similar to OEM. We have not looked specifically at the 954, but many OEM Hondas have about 1.5 inch rise. |
|
| QUESTION: What does it mean that it has !.5 inch rise, but is similiar to the stock rise on the GSXR? And do you know if I will have to lengthen my brake/clutch lines?
Thanks,
David |
| ANSWER: Those clipon are similar to the stock set up on some of the early 00's GSXR's. If your bike has no rise then you will need to determine who much extra you have in your lines. |
|
| QUESTION: I have a 08' 1000RR what would the degree angle be? |
| ANSWER: The angle on these clipons is 7 degrees, which is close to the stock angle. |
|
| QUESTION: will it fit for honda cbr 1000rr 06? |
| ANSWER: Yes, they will fit your bike perfectly. We had a customer try out that exact rise on that bike and they went on without a hitch. Note that the 1 tail description is wrong....the part number here is for the 1 1/2 inch rise, and the description says 1 inch. If you want a 1 inch rise, you want part number 12-1550. |
|
|
|
| Ask your question here: |
|
| Your email (so we can send you the answer): |
|
|
|
Event Schdeule
powered by WordPress e-commerce company