|
| Flush Mount Signals - Amber LED, Smoke Lens: Yamaha YZF R1 (02-11) |
NEW LOWER PRICE!
These unique, custom-designed flush-mount signals fit neatly into the fairing pockets of the factory blinker stalks. Our flush-mount signals give you bike a clean, slippery, serious look of speed. Because our flush-mount signals are shaped for each model bike, their integrated finish accentuates the streamlined designs. Our flush mount signals feature 8 high intensity amber LED lights behind clear lens shaped for an exacting, edgeless fit. |
| |
| Item no.Y04R1-SIG-SMK |
| Today$43.95 |
|
|
|
|
| Application Chart |
Diagrams |
Application
Notes |
|
| 2002 Yamaha YZF R1 |
|
|
| 2003 Yamaha YZF R1 |
|
|
| 2004 Yamaha YZF R1 |
|
|
| 2005 Yamaha YZF R1 |
|
|
| 2006 Yamaha YZF R1 |
|
|
| 2007 Yamaha YZF R1 |
|
|
| 2008 Yamaha YZF R1 |
|
|
| 2009 Yamaha YZF R1 |
|
|
| 2010 Yamaha YZF R1 |
|
|
|
|
|
|
|
|
|
|
| This item does NOT ship for free |
| Shipping charges will apply to this item. If you place your order now we will call with the shipping rate. If the rate is approved by you we will charge you the additional shipping. If the rate is NOT approved by you then we will cancel your order. If you do not wish to place your order now you can enter in the quantity you wish to order and your zip code in the Q&A section below and we will respond with a quote. |
|
|
|
| Additional Photos |
 |
 |
|
|
|
| WARNING: Laws concerning this product vary from state/province to state/province. Your state/province may prohibit its use on public roads or restrict its use to novelty, show use, off-road areas, or race facility areas only. In some states/provinces off-road uses are also prohibited. The manufacturer and retailer assume no responsibility for any use or application of this product in violation of any applicable law. Before installing this product, please check your state/provincial and local/municipal laws and regulations. |
|
| The Q&A on this Product |
|
|
| QUESTION: Does this product come in a pair or just one each? |
| ANSWER: This is sold as a pair. |
|
| QUESTION: There is no place to bolt these down to on an 05 R1. They provide washers, but they are too big to fit properly on the back of the fairing. Whats the deal? |
| ANSWER: 3 spacers go on the inside of the signal and the 1 washer goes on the inner side of the fairing (Back side) and that bolts the signal down. |
|
| QUESTION: do you need to drill or anything? and does the wiring on the aftermarket turn signal plug right into the stock one? |
| ANSWER: You do not have to drill anything on your stock bodywork these signals just bolt down to your plastics. Also the wire you will have to splice the wires.
|
|
| QUESTION: is this hard to install? |
| ANSWER: No, its just a matter of removing your stock turn signal and bolting these in place and then just wire the new ones |
|
|
|
| Ask your question here: |
|
| Your email (so we can send you the answer): |
|
|
|
Event Schdeule
powered by WordPress e-commerce company