|
|
|
|
|
|
|
|
|
|
|
|
|
|
| WARNING: Laws concerning this product vary from state/province to state/province. Your state/province may prohibit its use on public roads or restrict its use to novelty, show use, off-road areas, or race facility areas only. In some states/provinces off-road uses are also prohibited. The manufacturer and retailer assume no responsibility for any use or application of this product in violation of any applicable law. Before installing this product, please check your state/provincial and local/municipal laws and regulations. |
|
| The Q&A on this Product |
|
|
| QUESTION: Thanks for your reply.Regarding the rear brake disc you have listed below,
can you please check the item to see if the measurements match the numbers
listed below.If the numbers all match then it will work for my application.
I have taken dimensions from my original disc and are as follows: The
O.D.. of the disc is 210mm, I.D. is 82 mm, swept surface (from I.D. to O.D.
is 26 mm, 4 bolt mount pattern with 10mm diameter holes,bolt hole centres
at 100mm ( measured diagonally across from one another NOT adjacent to one
another ).Disc minimum thickness 4.5 mm( I think original thickness is 5 or
5.5mm). |
| ANSWER: Here are the measurements for the 08.4899.52:
OD |
|
| QUESTION: Hi,
I would like to know if you have a rear brake disc for my 94 Suzuki RGV250
(VJ22 model).I was on your web site in the Brembo disc section and found a
rear disc that looks exactly like the one I'm looking for........It is the
one pictured that is painted black ,inboard of the pad contact area.I have
taken dimensions from my original disc and are as follows:
The O.D.. of the disc is 210mm, I.D. is 82
mm, swept surface (from I.D. to O.D. is 26 mm, 4 bolt mount pattern with
10mm diameter holes,bolt hole centres at 100mm ( measured diagonally across
from one another NOT adjacent to one another ).Disc minimum thickness 4.5
mm( I think original thickness is 5 or 5.5mm).
If you have a specific rotor or another that would
work in standard style or wave style please let me know.Thanks.
|
| ANSWER: I don't have a specific rotor for your bike. The part number you have above is all I carry. Brembo concentrates on the front and rear of the European makes. Only the fronts are made by Brembo for the Japanese makes. Thanks. |
|
|
|
| Ask your question here: |
|
| Your email (so we can send you the answer): |
|
|
|
Event Schdeule
powered by WordPress e-commerce company