|
| BRAKE PRESSURE SWITCH ASSY, COARSE THREAD -- 10mm x 1.25mm |
These universal switches allow rearset users to operate the rear brake light. This all-in-one unit replaces the banjo bolt that connects the rear master cylinder to the rear brake line. You simply replace the bolt with this assembly and splice the wires into your existing brake light switch. The pressure inside your brake system then activates the brake light.
NO RETURN OR REFUND ON THIS ITEM!
|
| |
| Item no.03-0100 |
Retail: $19.99(PLUS shipping) |
| Today$19.95 |
|
|
|
|
|
|
|
|
|
|
|
|
| This item does NOT ship for free |
| Shipping charges will apply to this item. If you place your order now we will call with the shipping rate. If the rate is approved by you we will charge you the additional shipping. If the rate is NOT approved by you then we will cancel your order. If you do not wish to place your order now you can enter in the quantity you wish to order and your zip code in the Q&A section below and we will respond with a quote. |
|
|
|
This part is a MUST HAVE item if you are going to ride your Woodcraft Race Rearset equipped bike on the street. Woodcraft Race Rearsets do NOT have a mount for your brake light switch linkage. This switch comes with a replacement banjo bolt and a pressure sensor switch that senses when pressure is applied, and triggers your brake light.
The thread pitch can vary between different bikes IN THE SAME MODEL YEAR. Please make certain which thread pitch your specific bike has before ordering.
|
|
|
| WARNING: Laws concerning this product vary from state/province to state/province. Your state/province may prohibit its use on public roads or restrict its use to novelty, show use, off-road areas, or race facility areas only. In some states/provinces off-road uses are also prohibited. The manufacturer and retailer assume no responsibility for any use or application of this product in violation of any applicable law. Before installing this product, please check your state/provincial and local/municipal laws and regulations. |
|
| The Q&A on this Product |
|
|
| QUESTION: I have a 2008 GSXR 1000, I don't know how to determine pitch on the cf motorsports rear sets I have on my bike. Also would you recommend coarse or fine thread for my bike? |
| ANSWER: Yes, your bike will take a coarse thread switch. |
|
| QUESTION: Hello Again,I am also wondering if this product comes with the 2 new brass washers that I will need when I switch over to the new pressure switch. Please let me know,Thank you. |
| ANSWER: no, you will need to either reuse them or purchase them from your local bike shop. |
|
| QUESTION: would i need this, or the fine thread on my 02 cbr600 f4i? |
| ANSWER: All Hondas we have seen use coarse thread |
|
| QUESTION: will this fit a 03 Honda RC51 with Sato rear sets?
|
| ANSWER: The switch is independent of your rearsets....and yes, it should work with this model. |
|
| QUESTION: Will this fit an 07 GSX-R600? |
| ANSWER: Yes, it will |
|
|
|
| Ask your question here: |
|
| Your email (so we can send you the answer): |
|
|
|
Event Schdeule
powered by WordPress e-commerce company