|
|
|
|
| Application Chart |
Diagrams |
Application
Notes |
|
| 2006 Kawasaki ZX 10R |
|
|
| 2007 Kawasaki ZX 10R |
|
|
| 2008 Kawasaki ZX 10R |
|
|
| 2006 Kawasaki ZX 14 R |
|
|
| 2007 Kawasaki ZX 14 R |
|
|
| 2008 Kawasaki ZX 14 R |
|
|
|
|
|
|
|
|
|
|
| This item does NOT ship for free |
| Shipping charges will apply to this item. If you place your order now we will call with the shipping rate. If the rate is approved by you we will charge you the additional shipping. If the rate is NOT approved by you then we will cancel your order. If you do not wish to place your order now you can enter in the quantity you wish to order and your zip code in the Q&A section below and we will respond with a quote. |
|
|
|
| WARNING: Laws concerning this product vary from state/province to state/province. Your state/province may prohibit its use on public roads or restrict its use to novelty, show use, off-road areas, or race facility areas only. In some states/provinces off-road uses are also prohibited. The manufacturer and retailer assume no responsibility for any use or application of this product in violation of any applicable law. Before installing this product, please check your state/provincial and local/municipal laws and regulations. |
|
| The Q&A on this Product |
|
|
| QUESTION: for the 38 special bar ends dos it fit like stock bar ends whit the screws in the kit ??? thank's ! martin (quebec,canada) |
| ANSWER: Yes, we supply stainless steel hardware with these bar ends. |
|
| QUESTION: do u ship out to england? |
| ANSWER: Yes,no problem. Via US Postal |
|
| QUESTION: The side pipe that goes under the zx14 peg, is it good for drag racing? Will it burn my leg? My number is 704 890-7980 |
| ANSWER: The bar ends will work great on your bike. |
|
| QUESTION: The side pipe that goes under the peg, is it good for drag racing |
| ANSWER: The ber ends will look great on your bike..As far as your question goes ,I would log on to a drag racing forum. |
|
| QUESTION: Do you sell a set that fits the 636 (03) model? |
| ANSWER: Yes we do. |
|
| QUESTION: DO U HAVE THIS FOR ZX10R 05 |
| ANSWER: yes we do |
|
| QUESTION: I just got a set yesterday, and when I went to install them, the screw it comes with was too long and the bar ends dont mount flush to the hand grip, and the stock screws wont fit into the bar ends snug. The head sticks out from the end of the bar end. Any suggestions? |
| ANSWER: Please contact us so we can take care of the problem. Thanks, ask for William.
561-620-2852 |
|
|
|
| Ask your question here: |
|
| Your email (so we can send you the answer): |
|
|
|
Event Schdeule
powered by WordPress e-commerce company