|
| SUZUKI GSXR 600 / 750 06-07 STANDARD FENDER ELIMINATOR KIT |
This kit positions the tag in front of the back tire, giving the bike a much cleaner look! Very easy to install and includes LED tag light, LED turn Signals, all stainless hardware, load resistors, and instructions. Available in Black, Yellow, CLEAR BLUE or CLEAR RED. |
| |
| Item no.S0607GSXR600750STD |
Retail: $109.95(PLUS shipping) |
| Today$79.95 |
|
|
|
|
| Application Chart |
Diagrams |
Application
Notes |
|
| 2006 Suzuki GSX-R 600 (K6) |
|
|
| 2007 Suzuki GSX-R 600 (K7) |
|
|
| 2006 Suzuki GSX-R 750 (K6) |
|
|
| 2007 Suzuki GSX-R 750 (K7) |
|
|
|
|
|
|
|
|
|
|
| This item does NOT ship for free |
| Shipping charges will apply to this item. If you place your order now we will call with the shipping rate. If the rate is approved by you we will charge you the additional shipping. If the rate is NOT approved by you then we will cancel your order. If you do not wish to place your order now you can enter in the quantity you wish to order and your zip code in the Q&A section below and we will respond with a quote. |
|
|
|
|
|
|
| WARNING: Laws concerning this product vary from state/province to state/province. Your state/province may prohibit its use on public roads or restrict its use to novelty, show use, off-road areas, or race facility areas only. In some states/provinces off-road uses are also prohibited. The manufacturer and retailer assume no responsibility for any use or application of this product in violation of any applicable law. Before installing this product, please check your state/provincial and local/municipal laws and regulations. |
|
| The Q&A on this Product |
|
|
| QUESTION: can I remove the rear foot pegs for a cleaner look? |
| ANSWER: yes, i did on my 750. |
|
| QUESTION: So no drilling or splicing into wires? Just remove old fender, replace with this, and plug n play with the new led? |
| ANSWER: you have to splice the led light in. |
|
| QUESTION: those three led's for the plat, can i order those seperately? |
| ANSWER: yes, please call in to special order that. they are $15 |
|
| QUESTION: will this fit my 07 gsxr 750 |
| ANSWER: yes |
|
| QUESTION: where is the license plate light wired...and is there any drilling involved?? |
| ANSWER: NO drilling on this kit. The wire that comes out of the bike in the factory location is the wire you will use to hook this tag bracket up! VERY easy installation on this kit! Uses all 4 of the 10mm mounting bolts. |
|
|
|
| Ask your question here: |
|
| Your email (so we can send you the answer): |
|
|
|
Event Schdeule
powered by WordPress e-commerce company